Categories

Manufacturers

Dynatex Hi-Tack Gasket Spray

49358 | Dynatex Hi-Tack Gasket Spray
Price: $5.99
Product ID : 49358
Manufacturer: Dynatex

Purchase

Description

HI-TACK GASKET SPRAY PART NO. 49358 PHYSICAL PROPERTIES

Physical State................... Aerosol

Color/Appearance..............Red liquid

Odor...............Pungent Solvent odor

Specific Gravity....................0.92

Boiling/Cond. Point ...............>1000 F

Solubility............... Insoluble in water

Evaporation Rate.......... Dynatex Hi-Tack Gasket Spray dries quickly to a highly tacky film. This product was specifically designed to hold the heaviest gaskets in place during assembly.

TYPICAL APPLICATIONS

Bond and seal any type of cut gasket including: Rubber Felt Cork Paper Metal

FEATURES

Dries fast to a highly tacky, elastomeric film Oxygen sensor safe Highly resistant to automotive fuels and oils Remains tacky indefinitely can be applied in advance for convenience in assembly Temperature range -65 degrees F to 450 degrees F

DIRECTIONS FOR USE:

1. Provide adequate ventilation.

2. Surfaces should be free of oil, dirt and grease.

3. Mask areas that should not be coated.

4. Shake can with ball agitator for one minute. For best results, aerosol can should be at room temperature before spraying.

5. Holding can 8 to 10 inches from the surface to be coated, with can in upright position, press the nozzle and spray the product uniformly. Apply to flange surfaces and both sides of the gasket and the bolt threads. Avoid overspray. For best coverage, 2 to 3 light coats are required. 6. Wait for the solvent to evaporate before assembly. The product can be applied in advance and still remain tacky when assembled.

Comment on Facebook

Product Reviews

Login or Register to write the first review.

Products You May Like

54016
49410
Gas Tank Repair Kit
$3.29